Simplicity sw210 User Manual download pdf (Page 22)

BUILT-IN STITCHES – “N” NORMAL RANGE

ATTACHING FLAT ELASTIC

Place elastic and fabric under the presser foot.

Take a few stitches to anchor the elastic. Adjust the

width of the stitch to the width of the elastic.

Zigzag over the elastic, stretching the elastic in front of

the presser foot as you sew [Fig. 1].

SEAMING NYLON TRICOT

Use the double action stitch for quick and easy, one-step

seaming and finishing on tricot and other soft fabrics.

For 1/4” seam allowances, guide the fabric so the right

swing of the stitch forms just inside the edge of the fabric

[Fig. 2].

or 1/2” to 5/8” seam allowances, sew [Fig. 3], then trim

the excess fabric close to the stitc

hing [Fig. 4].

ENCASING ELASTIC

Create casings for 1/8” narrow elastic in minutes for

waistbands, cuffs, and craft items.

Place the fabric wrong side up under the presser foot.

y the elastic on top of the fabric, under the center of

the presser foot, and past the end of the fabric. Leave a

1/2” tail of elastic behind the foot. Begin sewing being

careful not to stitch the elastic [Fig. 5]. When sewing is

complete, pull the ends of the elastic until the desired

amount of fullness is obtained [Fig. 6]. Secure the ends

of the elastic with a straight stitch before sewing them

into a seam.

STITCH “C” - THREE-STEP ZIGZAG

STITCH “D” - DOUBLE ACTION

Fig. 1

g. 2

Fig. 3

Fig. 4

Fig. 5

RANGE STITCH WIDTH LENGTH FOOT

N C 3-5 2-3 All-purpose

RANGE STITCH WIDTH LENGTH FOOT

N D 1 1 All-purpose

RANGE STITCH WIDTH LENGTH FOOT

N D 5 4 All-purpose

Fig. 6

Elastic casing

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 34 35

No comments

Simplicity sw210 User Manual Page 22