Synergy Nano Technical Manual, Revision -
Page 175
RS-232
To communicate over RS-232, plug a serial cable into your PC and connect the other end to the serial port
on the chamber.
On the SimpleComm, select the RS-232 tab and
set the port number to the same port number
specified on your PC. To determine the port
settings on the PC, go to Start/Settings/System,
select the hardware tab, select Device Manager
and expand the Ports icon.
The Synergy Nano’s RS-232 port settings are hard-
coded to: 19200 baud rate, no parity, 8 data bits
and 1 stop bit. RS-232 does not need address
settings.
Once the settings are complete, press the
SimpleComm’s Connect button. The status label
will read: port open.
Comments to this Manuals