Synergy Nano Technical Manual, Revision -
Page 262
17.2 Controller Mounting
The Synergy Nano is ¼ DIN form factor which makes the retrofit process fast and easy.
17.2.1 Controller Mounting
The Synergy Nano is mounted from the front of the panel as shown in the figure below. Two clamps (P/N
TE2047) are installed on the top and bottom of the controller to secure it in the panel. The panel cutout is
shown in the figure below. An alternative front mounting arrangement is also possible with the use of the
bezel P/N TE1536.
Synergy Nano
Mounting Clamp
P/N TE2047
2
Re
uired
Synergy Nano
Mounting Clamp
P/N TE2047
2
Re
uired
Tighten
with Allen
Wrench
Provided
Comments to this Manuals